🖤 Screwless strength meets sleek simplicity—mount smarter, sail stronger.
The SEAWORTHY INNOVATIONS Stern Pad Jumbo Black is a polymer mounting kit designed for large 3D scan transducers. It installs in under 5 minutes without screws or epoxy, preserving your boat’s hull. Measuring 6.5" x 4.75" x 1", it delivers twice the hold strength of the standard pad and supports bottom painting. The kit includes the jumbo pad, three screwless cable clips, and an installation kit. Note: Not compatible with LiveScope or equivalent transducers.
| Item Package Dimensions L x W x H | 6.85 x 5.39 x 1.89 inches |
| Package Weight | 0.34 Kilograms |
| Item Dimensions LxWxH | 7.1 x 6.1 x 1.9 inches |
| Item Weight | 0.73 Pounds |
| Brand Name | SEAWORTHY INNOVATIONS |
| Model Name | SW1004 |
| Material | Polymer |
| Suggested Users | "" |
| Manufacturer | Seaworthy Innovations |
| Part Number | SPJBLK0000 |
G**S
Seems good
simple install, did not feel like a solid material? Screws will strip very easily if not careful. But it is installed
M**Y
Worked great 6 months in so far awesome
Super good quality I used it on my wake boat to mount my depth finderStop putting holes in my boat hahahah Jack sparrow lol
K**Y
Don't drill in your transom
I did not want to drill holes under the water line of my new boat, so I purchased this mounting pad. It installed easily, but I found that there was a little gap on one edge due to the fact that my transom is not perfectly flat. This pad is very flat on the mounting surface. I ended up buying a tube of marine adhesive and worked it under the gap, then formed a nice bead on the top and left and right sides, leaving the bottom un-caulked to allow any water to drip out.I mounted it nearly flush with the bottom of the boat. The transducer bracket screwed in securely and I adjusted it in accordance with the mounting instructions for the depth finder. The depth finder shows accurate speed even at high speed (35 mph on my boat), so the bracket is not generating excessive turbulence.Without holes in the transom, I have no points of leakage!
D**S
Great Product
Good seller and a good product
F**D
This things works with a caveat
Long story short, ensure that the area you are putting on is flat and that you can apply pressure for the glue to stick. I put it on a Jon boat the first time; it didn't stick well and pulled off and fell into the dirt. I bought a new one because I knew I had messed up, no fault of the company.I moved over to a flatter spot with no dents, used two ratchet straps to a bolt inside the boat, and wrapped the other end around the trailer to crank down it to lay flat. It worked fine could still see minor lifting on one side; I filled the gap with 3m 5200 and cranked it down with a ratchet strap.Problem solved. This thing will probably never come off and holds a 3d scan transducer with no problem with a Stainless steel 10x 3/4" screw. Make sure you have a way to make it adhere and lay flat is my advice
J**2
Do as instructed
Worked as advertised. Great product, time will tell but I suspect the adhesive will do the job. Transducer works great and the install was perfect.
B**.
No issues after years of use.
Lasted for years. Very good product.
H**N
simplicity
this item would have been great except where i needed to install it on the boat, there was not enough room on the transom.
Trustpilot
2 weeks ago
1 month ago
