4pcs Hall-Effect Joysticks Replacement for DualSense PS5 Controller, 3D Analog Sensor Wheel Thumb Sticks Rocker Module Replacement for PlayStation 5 Controller

Have two dualsense controllers with jitter on the right sticks. I had heard hall effects would correct the problem but didnt want to waste the high cost at the moment. And after having the same issue with ps4 controllers years back, I knew the level of work it would take to change these. I bought the tiny film with potentiometers first to try out. Those where a lot cheaper and it was a lot easier to just put a little solder on top of the original stick contacts. Tried those on my dead ps4 controllers and as I thought, it didnt do much. With those tiny film potentiometers you adjust on one end but the other side of the travel gets messed up. Those where more luck than a guaranteed solution. After a year finally saw this hall effect ones on a reasonable price and decided to buy them. Be advised this is a complicated replacement to do. The toughest part is removing the original ones from the controller. Controller can be opened with a quick internet video. But desoldering the old one takes A LOT of patience. If your up for the challenge it'll fix your dead ps5 controller for sure. Just take your time a dont rush. Once you get the original one off its easy putting the new one in and just taping the solder points. To calibrate them after, just go on the internet and look for a video. Its easy and again, PATIENCE is the key on removing the old one AND calibrating the new one. From a 50 dead zone setting on apex were down to a 0. Oh and I only replaced the bad one. The other joystick on the controller was fine. If it also goes bad along the way I'll just do the same.

These are great. I don't have skills or equipment to install them so had a local game shop do it for two PS5 controllers. It's been about 2 months and have zero issues on controllers that used to have stick drift issues! If you know how to solder and can calibrate the controllers, what can go wrong at this price point? Highly recommend!

These Hall-effect sticks restored my DualSense responsiveness—no drift or dead zones. Installation took care and patience, but gaming now feels as good as new. Be careful how you solder this in place, you could still get some drift if you don't place the magnet in place at a 90-degree angle.

The media could not be loaded. Exact fit for PS5 dual sense controller, joystick replacement, fix. However, the controller will notice the difference from this and the original joystick module, as the controller will not respond to the reset button as usual but will operate normally, though the reset led feedback may not respond as usual.

No le doy 5 estrellas porque en el momento después de configurar y calibrar las palancas u el movimiento da un poco de drift.

5/6 worked perfectly, 1 of them the magnet in the y position was completely screwed up, i opened it up and flipped it back around but the magnet was completely dead. Voltage was 1.8v on all pins so no issues there. Decent value, would be better to buy off of AliExpress for cheaper since these sets tend to have one or two that don’t work.

These joystick are much better than the older ones after fine tuning I was able to get down to a 1% error in the sticks. They are not hard to install if you have the right tools they feel smoother and I saved money vs buying a new controller ot send it off

Well, the install was great. Did some testing and it was good. Well, when we played diablo 4, the R3 on the joystick collapsed and quit working. Other than that, it fixed the drift, and felt alot more premium. Just be careful when buying