Front Bumper Lower Lip Splitter Carbon Fiber Look Fit for 2015-2019 Chevy Corvette C7 Z06 & Grand Sport Replaces OEM #22922352 ABS Plastic - Hydro-Dipped Carbon Fiber

This splitter fit my 2019 grand sport beautifully. I did not have an OEM splitter so I don’t have much to compare it to. Most of the holes for the screws were correctly aligned. I did have to drill out two or three no big deal. I used 3M double sided tape, which is a must towards the nose of the car but everything went together fairly smoothly. Finished product looks beautiful.

Easy install took me 1 hour. It had all the screws but not the rivets. I had plenty so it wasn't a problem. Value was better than paying for carbon fiber. You can see the difference so but the abs is durable.

My friend and I installed this front-end splitter. Only gave 4 stars on easy to install, as we had to tap 2 screws that did not line up. May have been our mistake, not sure. Once the 2 - sided tape is on it is hard to remove. I used extra strength tape. The split looks awesome.We had to use ramps with 2X10 to raise car enough to make it workable

A good looking fake carbon fiber splitter. Predrilled holes are just about right to match the C7 underbelly, had to readjust the air-dams to get it to line up right. The extra included screws/washers won't hold up long term, recommend buying 5/16th plastic rivets and drilling into the body adding those to hold the front-end more secure, the included screws will strip out if you drill the body for those.

The quality of this product is OEM. However, you will need to buy your own 3M tape. The pre drilled holes are ~.5 in off. Otherwise, great product, would recommend this.

It’s not carbon fiber it’s plastic and it came damage

I’d recommend using rivets for the install. I used 3/16 with 1/4” grip aluminum rivets. They don’t supply any. Maybe 4 if the 20 or so holes lined up right.I ended up drilling half inch holes in the splitter and getting fender washers. I then decided to just rely on the 2 middle screws and two end screws and did 12 or so rivets. I was worried about the self tapped hardware coming loose, as it already was, and maybe catching a screw in a 600$ tire.The rivets and double sided 3M tape holds solid and and I wish I didn’t waste so much time drilling trying to make the old hardware work. End product looks great. 3 stars because of next to nothing lining up. The two middle holes did thankfully line up which helped align the splitter to the bumper.