KV Rear Mounting Bracket Anochrome (Single)

After building 4 cabinet drawers using ripped wood, to fill the space between the face frame and the walls (and using wood spacer attached to the floor for the center stile) to support the glides I ran into a problem with my island counter: there was an electrical conduit running in the back which meant I had to raise the slides and drawers.I decided to order a front and rear hanger from "Green Woods and Goods" so that I could adjust the slides above the conduit. They work great!!the only problem I had with the rear spacers (front simply attaches to the face frame) is that the rear wall was only 1/4 inch thick so, putting even a small screw in would show on the outside so, I glued a strip of wood to the inside back wall which holds the bracket well and, I believe gives it more support.While the cost (with shipping it makes these a little more expensive than I thought they should be (if you order more than a few the total cost comes to about $2/fitting)), the savings in labor makes them worth it and, the final product is more esthetically pleasing. I just wish I had ordered these for all the drawers.

Better value when buying several at once to save on shipping per item. It allowed me to install slides in a non square'ish cabinet situation where it would have been annoying to make a bunch of individualized spacers. Seems sturdy. I only put a nut/bolt through the longer center slot to a couple of slides that seemed to not seat in there all the way, but that could certainly be from the wonky cabinet and no fault of these brackets (likely the case).It's handy to use these for face framed cabinetry, but if the cabinet walls and face frame proud-ness had all been consistent, I wouldn't have bothered with these brackets and just ripped (on the table saw) consistent spacers. So they made an annoying situation easier :)I don't know about you, but it's the fiddly parts of getting things to fit just right or look just right that can take the longest. So these brackets were WELL worth it!

Retrofitted old 4 drawer oak file drawer to modern glides. Made the file cabinet much more useful and easier to open, close and hold open the drawers. Would not have set this without the face frame and rear mounting bracket.

Bought these together with the corresponding full-length drawer slides to replace contstantly breaking European style drawer slides with plastic fittings. These work very well and are relatively easy to adjust. It is probabably easier to intall them when cabinets are being constructed than retrofitting but both ways work.

Purchased for the rear mount of shelving slides for kitchen cupboards. this bracket simplifies the rear mounting and makes a hard job easy. it is well worth the price paid to relive the stress and frustration of mounting the glide in the rear. The least amount of time spent inside a cramped cupboard trying to hold, drill and screw is definitely better.

The item has not been installed yet but it does fit and is well constructed.

Does not have snap in on the top and bottom. Fake product. Had to return and order from someone else.

Needed these to install full extension slides in cabinets. The local big boxes didn't carry them and specialty places wanted a fortune, I needed 26 so these saved my wallet. They worked like a champ with the slides.