Quick Release Plate with Arca-Swiss

I use this on a Manfrotto N-608 video head, a Nikon Z9, and a Peak Design plate. If you have shopped around for third party Arca-swiss components you know that they aren't always compatible due to manufacturing tolerances. This one fits perfectly (well, to be honest it might be just a tad too large so it doesn't slide freely on the Manfrotto head before securing it, so you have to work it a little, but other than that it's spot on).

Very well built as always. Small note: if you are looking for a good solution to attach your Peak Design plates to your ronin, this is it. It fits both the PD Standard Plate and the PD Dual Plate. Fair warning though, the PD Standard Plate is super low-profile so the camera clearance is too low to use the DJI lens support bracket with my Sony a7S3 with a 16-35/f2.8 lens. For that reason I recommend using the PD Dual Plate to give it a little more height. Otherwise, if you don’t plan on using the lens bracket, don’t worry about it. If you do end up using the PD Dual Plate, you will need to mount the plate sideways on the camera for it to fit as the manfrotto cutouts get in the way in the front and back. It’s a little janky but it works great and is still solid! Overall, it’s a good solution to be able to keep my PD quick connect plates on while using my gimbal. Highly recommend!

Using this alongside the Canon C50’s power cage mount across my tripod and gimbal allows me to switch between them in about 20 seconds using just the arca swiss sled on this plate. Also nice to have the track if I need to balance that axis for a unique rig.

For those who mention that it doesn't fit the Ronin RS3, there is a fix. The lever that locks the plate into the gimbal can be adjusted with a T6 torx screw driver. If the plate doesn't fit at first, try adjusting the lever. That's what I did and it fit.

casi identico al original hace su funcion muy bien

If you have: a DJI RS 4 Pro, Nikon Z9, and small rig cage, THIS IS THE ACCESSORY YOU NEED. It is nice to be able to use the integrated arca swiss mount and keeping the entire camera (and thus the center of gravity) low on the gimbal arm makes it much easier to balance. the part is well machined and integrates perfectly with the RS 4. Don't hesitate. Just buy it.

The plate is very well made. The safety catch is on the opposite side of Zhyiun Weebil 3E. Even if I made adjustments (drilling a bolt through to work as a safety catch) the thumb screw at the back interferes with the roll motor of the gimbal.

This is pretty much a must-have for someone who switches a camera back and forth from a gimbal to a tripod. This saves to much time from not having to rebalance the gimbal!

Works really well with my DJI RS3

Works perfectly with DJI Ronin SC-2. I slid my old lower plate off and slid this new arca swiss lower plate on within seconds. It works perfect. I was annoyed I received a used/open box one though I paid for a new one. No harm this time though since it's metal and there were no scuffs or scratches on it.

Great product

Exactly what I needed. Fits a PeakDesign plate and many more Arca Swiss. Similar if not same built quality as the original from DJI.

It feels really cheap and it's basically the exact same as the DJI Arca Swiss mount that comes with the DJI gimbals… Only thing is that its tightening solution is worse than the DJI's as this one you screw to tighten so it would come loose, whereas the DJI one actually holds its tightness with the lever.