🚗 Rev Up the Adventure!
The jiaruixin 24V555 Gearbox Motor is a high-performance electric motor designed specifically for kids' ride-on cars. With a robust 18000 RPM speed and universal compatibility, this motor ensures a thrilling yet safe driving experience. Its quick-change wire connectors make installation a breeze, allowing for easy upgrades and replacements. Built from durable materials, this motor is perfect for enhancing your child's outdoor adventures.
D**C
Very good quality
My kid has been driving with this motor for 2 hours straight and the motor has good power and very strong I even hoped on it for a bit and I'm 185 pounds
O**E
Great and durable.
Been running these at closer to 30 volts for a year now. Connected to a cheap ebike speed controller on my sons Jeep. The thing pops wheelies and the motors barely get warm to the touch. I did have to replace one after about a year, but these have taken a lot of abuse, and Ive run them above the spec'd voltage the entire time so I really cant complain. And for the money, I can't complain.
Z**Y
BROKE WITHIN THE FIRST HOUR
My son only rode on this new motor for 20 minutes and the gearbox broke. Not worth $20 at all. Everything fit perfect and was easy to install but was a cheap gear
K**N
Used this with a 20V Dewalt Battery
Bought 2 and installed one of them due to waiting on building a bracket for the 2nd motor. This 1 motor can handle 2 kids and initially it was being used for at least 30 minutes going back and forth. The 20V 5Ah battery still had a full charge.
D**D
Thought it was perfect for that 12v to 24v ride-on upgrade, but then...
The media could not be loaded. Used two on a 12V to 24V upgrade for a Best Choice Products Jeep (comes stock with a 9k rpm gearbox and 12v motor) - easily moving along at 6 to 7 mph now on a solid surface.Edit: after 2 hours of use, the final drive gears on both beveled out to the point where they won't engage with any resistance from the tire. You can see the secondary gear doesn't fully engage with the final drive gear, so any torque that's applied over time will cause beveled, uneven wear to the point of failure. Looks like a series of washers on the final drive gear may give it enough offset to reduce failure.
E**N
Cheap built.
pops and slips, melted gears within first hour of use buy 3 year old
M**E
Poor quality
It worked fine for a couple of months until it got hot, shorted out, and almost started on fire.
F**K
Junk!
Purchased 2 of these motors both burnt up within 2 hours. Total waste of money!
Trustpilot
2 months ago
1 month ago