Axminster Workshop Pair of Blade Clamps for AWVFS Scroll Saw

I've ordered these a few times now and they have always been good.However the last pair were very brittle and shattered I think it may have been a fault in manufacturing.I informed the company and was sent a replacement next day. These work fine and I'm happy with them.HTH Ian.

Very poor quality! Two out of four have arrived broken, replacement refused only refunded, only purchased because can not find these style clamps anywhere else. They, however are so easy to use when they do work so have just got to take the good with the bad ! 👎

I fitted them to an Einhell scroll saw and they are better than the originals.

Second set I've had to purchase.Very brittle

hello I had a pair of blade clamps for a scroll saw from you which I have had others from you which was ok I know it was 2022 I had the last lot which I did not used be cause the others was ok I open them today to use they don't open you can not put the blades in that's the pair can any thing be done to exchange them because its a item you don't change in a scroll saw very often . sorry about this no way I can open them they are ceased. anyway thank you.

I have been using these clamps for a few years now, the cheaper scroll saws have blocks to fit pinless blades, to fiddley get these clamps makes life easier just bolt in place of the old ones, tip! Look at Axminster there are 2 sizes both do the same job but l have found the shorter ones last longer, l use my saw a lot, great fun

It does the job…it carries pin and non pin blades and converts existing pin blades carriers on certain scroll saws.The down side is why I gave it 3 stars you don’t know when this part will crack on the rear because the part is weak metal….I think it is not a machined part and does not flex very well when tightening the side screw holding the unpinned blade….admittedly it is a very fine gap but even so I have had them split on the rear and across the narrow part when held in position….this the third set broken in six years after a lot of use….there is no alternatives so you have to trust it lasts with careful use.

Purchased to replace blade holders in an old scroll saw, that only fitted pinned blades, all worked out fine, can now use both pinned and plain blades.