Rust Bullet Solvent

It's a rust bullet product. I've used the rust bullet treatments in the past with full satisfaction. Unlike other products specifically rust "encapsulators" which require laborious treatments of rusted surfaces.. bullet works with minimal prep. Onto the rust bullet thinner. While not used yet, I'm expecting the following: that 5% thinning ratio will allow Rust Bullet to freely spray through a pneumatic spray gun. Hoping cleanup to be easier of application equipment used. Not affect the durability of the actual Rust Bullet rust stop product. Rust Bullet is VERY difficult to clean up after it dries. Always wear gloves. I'm hoping this product will earn the high rating I gave it and act well with both cleanup and thinning.

Is a very good product even you can use with a regular paints Amazing.

worked as expected, had purchased a quart of the silver bullet and skinned over. Broke the seal added the solvent and back in business.

Didn’t quite work as well for me. Definitely a strong solvent though.

A little more expensive but the best solvent for Rust Bullet epoxy paints. Don't use more than 5 percent to thin paints otherwise it will cause "Solvent Pop". This is because all the solvent has to evaporate (4 hours) before epoxy hardens, otherwise solvent and will try to escape through the epoxy, causes bubbles. Use for quick cleanup of equipment, can be followed by less expensive lacquer thinner.

It’s nice. Better with ice though.

This stuff is the best if you want to remove paint or anything that been sitting to long Just don’t use it on plastic or acrylic

Used it before, cuts like xylene with oil paint